We can notify you when this product is back in stock by sending you an email.
What email should we reach you at?
This is a Chopper Fender made by Dixie. It is unfinished formed sheet steel, and is 1/16" or 2mm thick. Its length, measured from outside edge to outside edge, straight across under the fender as it stands unsupported on a table-top is 291/8" or 74.6cm. The length inside edge to inside is 29 1/16" or 74.2cm. The outside circumfrence or length following the outside as though it were part of a large circle, is 40" or 101.5cm. The inside circumfrence (same as before, but this time around the inside of the fender), is 39 1/2" or 100.5cm.The fender width straight across, outside edge to outside, is 5" or 12.6cm. The measurement for the same distance, only from the inside edges this time are 4 7/8" or 12.3cm. The circumfrence of the width of this fender are 6 1/4" outside to outside or 16.1cm in metric. The same measurement inside edge to inside edge is 6" or 15.4cm. The down-turned or "rolled" edges on this fender are of a 1" radius or in metric 2.65cm radius. There are no dents or dings on it, but it doess have some spots of rust on it from water damage suffered by a section of our old facility. There are no mounting tabs on this part as to allow you to totally customize your bike the way you want it.
There are no customer reviews for this product. However, you can be the first person to add a review for this product.
(Your browser will be redirected back to this page)